Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Yorkville Roofing & Maintenance has been installing skylights in Yorkville for 23 years — every one leak-free.
The curb is the foundation of every skylight installation. We frame it between existing trusses or rafters with doubled lumber to carry the load. The roof deck opening is cut precisely — no oversizing that weakens the sheathing. The skylight flange seals to the curb, and the flashing system integrates the unit into the existing shingle field so water runs over the flashing, not under it.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Roof Opening & Framing
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Seal Integration
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Final Seal & Trim
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What Yorkville Customers Say
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
Why Choose Yorkville Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Code Compliant
Every skylight installation meets CA building code for structural framing, energy performance, and egress requirements. Permits pulled when required.